Archive for August, 2012

CNC Plasma | Laser Crosshairs

by on Wednesday, August 1st, 2012

Been a while since I did a write up for this blog. I guess it is overdue.

 

A couple of weeks ago I was trying to line up a sheet on the Plasma table and struggling to locate a part within a piece of material very close to the same size as I was planning to cut. I told myself, “Self you need to make something to help with this little issue”. I only talk to myself on very rare occasions. Stop being so judgmental.

 

I decided to take a trip to the hardware store to see what I could use to make a device to locate my sheet. First thought was a device that went off of the edge of the table but seams too simple. So then I though about using a laser to help locate the sheet. Sounded like a nice little project. So I went in search of some sort of laser line generator. Off to the laser level isle. I found a cheap little level that had a laser line that could be rotated for around 15 bucks. Was hoping for something a little cheaper because I would need two of these.

I started off with just purchasing one (tight budgets suck) to make sure it would work as I expected.

(more…)